🔧 WhatWrench· tools for any car, any jobAll tool listsTry the app free

Tools you need for wiper blades on a 2014-2019 Toyota Corolla

Easy · 10-15 minutes · Updated 2026-09-28
Must-have tools
  1. Correct wiper blades, 26 in and 18 in
  2. Microfiber towel
  3. Flathead screwdriver (optional, hook release)

This is about as simple as car maintenance gets on the E170 Corolla. Both arms use plain J-hook ends, the driver blade is 26 inches and the passenger is 18 inches, and the whole job takes under fifteen minutes with nothing but your hands and a towel. Blade sizes are identical across every trim and both the 2ZR-FE and 2ZR-FAE engines, and no Corolla sedan of this generation has a rear wiper.

The one thing people get wrong is lifting the driver arm straight up: it hits the A-pillar trim. Swing it toward the middle of the windshield first, then raise it. The other common mistake is skipping the click check, so make sure the connector tab snaps home and give the blade a firm tug before lowering the arm.

Which store near you has these? WhatWrench checks the shelves at your nearest auto parts and hardware stores.Find them near me

Complete tool and parts list

ItemType
Wiper blades
26 in (650 mm) driver, 18 in (450 mm) passenger, J-hook
The replacement blades themselves; sizes are the same for all E170 trims.
Partsshop
Microfiber towel

Lay over the windshield to protect glass if an arm snaps down, and to wipe the glass clean.
Consumablesshop
Flat-blade screwdriver
Small, 1/4 in tip
Helps press a stiff release tab or pry a stuck blade off the J-hook.
Recommendedshop
Glass cleaner
Ammonia-free automotive
Clean the windshield and old rubber residue so new blades do not chatter.
Consumablesshop
Isopropyl alcohol wipes
70% or higher
Wipe the new blade rubber and glass to remove mold release and wax that cause streaking.
Consumablesshop
Combination wrench or socket
14 mm (wiper arm retaining nut)
Only needed if you are also removing or repositioning the wiper arms themselves.
Recommendedshop

Differences within the 2014-2019 generation

No difference. The 1.8 L 2ZR-FE and 2ZR-FAE Corollas use the same 26 in driver and 18 in passenger J-hook blades across all trims and model years 2014-2019.

Torque specs

Wiper arm retaining nut (only if arm removed)verify in the service manual

How the job goes

  1. Park with the wipers in their normal rest position and turn the ignition off so the wipers cannot cycle.
  2. Lay a folded towel over the windshield below each arm as insurance against the spring-loaded arm snapping back onto the glass.
  3. Lift the driver-side wiper arm off the glass until it locks upright. Swing it toward the center of the windshield first so the blade clears the A-pillar trim.
  4. Rotate the blade so the J-hook connector is visible. Press the release tab on the underside of the plastic connector.
  5. Slide the blade down along the arm to unhook it from the J-hook, then pull it free. Do not let the bare metal arm fall onto the glass.
  6. Fit the new 26 in blade: slide the hook through the connector until the tab clicks. Tug the blade lightly to confirm it is locked.
  7. Lower the arm gently back onto the glass in the correct rest position.
  8. Repeat for the passenger side with the 18 in blade.
  9. Wipe the new rubber and the glass with alcohol, then run the washers and wipers for a few cycles and check for chatter, streaking, or contact with the A-pillar.

Watch out

The 26 in / 18 in J-hook sizing is correct for all 2014-2019 Corolla sedans (including L, LE, LE Eco, S, SE, XLE, XSE); double-check your old blades before buying, since a previous owner may have fitted odd sizes.

Frequently asked

What size wiper blades does a 2014-2019 Toyota Corolla take?

26 inches (650 mm) on the driver side and 18 inches (450 mm) on the passenger side, both with a standard J-hook (hook-type) connector. This applies to every E170 sedan trim.

Do I need any tools to change Corolla wiper blades?

No. The blades unclip by hand with a press-tab release. A small flat screwdriver only helps if the clip is stiff or corroded.

Why do my new wiper blades chatter or streak on my Corolla?

Usually the windshield still has wax or road film on it, or the blade rubber has mold release on it from the package. Clean the glass with ammonia-free glass cleaner and wipe the new rubber with isopropyl alcohol. Persistent chatter can also mean a bent arm with uneven spring pressure.

Does the 2014-2019 Corolla have a rear wiper?

No. The E170 Corolla is sold only as a sedan in North America, so there are just the two front blades. The Corolla iM hatchback is a different model and does have a rear blade.

Other jobs on the 2014-2019 Toyota Corolla

Oil ChangeFront Brake Pads and RotorsRear Brake Pads and RotorsBattery ReplacementSpark Plug ReplacementAlternator ReplacementStarter ReplacementCoolant FlushSerpentine Belt ReplacementTire RotationHeadlight Bulb ReplacementThermostat ReplacementFront Strut ReplacementCabin Air Filter ReplacementEngine Air Filter ReplacementTransmission Fluid ChangeFront Wheel Bearing ReplacementOxygen Sensor ReplacementWater Pump Replacement

Wiper Blade Replacement on other vehicles

2015-2020 Ford F-1502021-2024 Ford F-1502014-2018 Chevrolet Silverado 15002019-2024 Chevrolet Silverado 15002009-2018 Ram 15002019-2024 Ram 15002012-2017 Toyota Camry2018-2024 Toyota Camry2020-2024 Toyota Corolla2013-2018 Toyota RAV42019-2024 Toyota RAV42005-2015 Toyota Tacoma2016-2023 Toyota Tacoma2016-2021 Honda Civic2022-2024 Honda Civic2013-2017 Honda Accord2018-2022 Honda Accord2012-2016 Honda CR-V2017-2022 Honda CR-V